The NET List
158 Manpack Transceiver 2110 series Reference Manual
Settings in the NET List
Name
The NET name may be any meaningful name that you want to assign to the NET. The
name may be up to 20 alphanumeric characters including spaces. The NET name is only
used for reference within the transceiver. It is not part of the NET configuration data.
Address
The Address setting contains the global address used by all stations that have the NET
programmed in the NET List. The address may be up to 15 alphanumeric characters
however, for efficiency of NET calls, it is preferable that the address be limited to
3 characters. You should choose an address that is not the same as any self addresses in
the NET or wider communication audience.
Network
The Network setting refers to the network containing the channels to be used with the
NET. This is selected from the pre-defined list of networks in the Network List. You can
set up two NETs with the same address but with different networks, say one for Group
privacy mode and one for Plain privacy mode. If the networks have the same channels,
then the Member Address setting in each NET should be identical as calls may be
received via either network (see page 146, Privacy Mode).
Member Address
The Member Address setting contains a sequential list of the self addresses of all
members of the NET. The station uses this list to calculate the response slots, so each
station in the NET can determine when an automatic response is required after the
initiating call. A member address may be up to 15 alphanumeric characters however, for
efficiency of NET calls, it is preferable that the member addresses be limited to
3 characters. To preserve an empty slot use the null address (@@@) in a member
address position.
NOTE
In the following discussion, you must log in as administrator to see the
NET List (see page 128, Logging in to admin level from user level).
CAUTION This setting must be the same in all member stations.
CAUTION This setting must be the same in all member stations.
CAUTION This setting must be the same in all member stations.
To Next Page
Loading...
Need help?
General
