Controlling user access
468 Manpack Transceiver 2110 series Reference Manual
Introduction
You can control user access to certain areas in the user interface for the 2110 series
Manpack Transceiver by entering special configuration commands in the Message 10
entry in the Control List. These commands may prevent accidental changes to setup
information, enable or disable certain features, hide or show information on a need-to-
know basis, and set up how the transceiver operates when certain key sequences are
used. Entering these commands into the Message 10 entry in the Control List in NSP
enables you to set up this behaviour within the profile.
You can:
• control access to the List Manager in total, or allow/restrict access to certain
functions (categories LMA, LM, see page 470, Controlling access to the List
Manager)
• control access to the admin level (category BAL, see page 473, Controlling access
to admin level)
• control access to the call types that can be used to make a call, except when they
have been included in an Address List entry (categories ACT, BCT, see page 474,
Controlling access to call types)
• control access to holding CALL and hence prevent changes to calling information
(categories HCD, CTE, see page 475, Controlling access to holding CALL)
• control access to creating a channel in free tune (category FTCD, see page 475,
Controlling access to creating a channel in free tune)
• control access to the CES-128 voice encryptor options (categories BSP[I],
SOA|SOD|SOS, SS<D|R>, U, H, see page 476, Controlling access to CES-128 voice
encryptor options)
• control access to the AES-256 digital voice encryptor options (categories
SOA|SOD|SOS, U, H, R, D, see page 479, Controlling access to AES-256 digital
voice and data encryptor options)
• control access to erasing secure keys via the + SEC hot-key sequence (category
DSE, see page 481, Controlling access to erasing secure keys)
• enable medium power level in the transceiver (category MPE, see page 481,
Enabling medium power level)
• enable the automatic removal of an incoming call pop-up (category TIC, see
page 481, Enabling the automatic removal of the incoming call pop-up)
• enable format options for GPS information (category GPS, see page 482, Enabling
GPS format options)
• enable access to streamlined user interface options (category UI, see page 483,
Enabling user interface options)
• enable access to viewing site manager information (category SMO, see page 484,
Enabling access to site manager information)
• enable access to priority messaging options (category PM, see page 486, Enabling
priority messaging options)