Operating the transceiver
98 Manpack Transceiver 2110 series Reference Manual
Tuning the antenna
Automatic tuning
If the transceiver is connected to an automatic tuning antenna, it tunes the antenna
automatically when required.
To tune the antenna when you select a channel:
1 Select a channel in the Channel List (for help see page 71, Selecting a channel).
1 Press then release PTT.
A message is displayed to inform you that tuning has begun, and the transceiver
makes a series of short beeps. Tuning typically takes 1 to 2 seconds.
If tuning fails, a message is displayed to inform you of this, and the transceiver
makes an error beep. You may need to manually tune the antenna (see page 99,
Manual tuning).
Removing the tuning message
To remove the tuning message before tuning is complete:
1 Press .
The beeps continue until tuning is complete.
Aborting automatic tuning
To abort automatic tuning:
1 Press PTT.
A message is displayed to inform you that tuning has been aborted, and the
transceiver makes an error beep.
WARNING
Before using the antenna system see the safety information provided on
page 491, Radiation safety.
To Next Page
Loading...
Need help?
General
