Hot key examples
390 Manpack Transceiver 2110 series Reference Manual
Example 3: displaying and/or changing a setting in the Control List
This example shows you how to create a macro to display and/or change a setting in the
Control List. You can then change the value or press to leave it as it is. This example
shows you how to create a macro to display the Cfg Alert Tones entry in the Control List,
allowing you to change the value if required.
When you run this macro, the transceiver:
• goes to the Cfg Alert Tones entry in the Control List
• displays the current value
• waits for you to act
To create this macro:
1 Log in to admin level (for help see page 128, Logging in to admin level from user
level).
1 Press until Main Menu is displayed.
1 Scroll to Control, then press .
1 Scroll to Cfg..., then press .
1 Scroll to Alert Tones, then hold .
A question mark is displayed at the end of the top line to indicate that you can now
change the value.
1 Hold to open the List Manager.
1 Scroll to Macros..., then press .
1 Scroll to Create macro, then press .
The transceiver asks you to select the action you want the macro to perform.
1 Scroll to Display value, then press .
The transceiver asks you to select the timing with which the macro operates.
1 Scroll to Waits, then press .
1 Press the key to which you want to assign the new macro.
1 Scroll to the macro you want to have in the list immediately after the new macro,
then press .
1 Type a name for the macro, then press .
The macro is created and assigned to the key, and the List Manager remains open.
To Next Page
Loading...
Need help?
General
