Codan 2110 series - Selcall Command

Operating the transceiver from a computer
Manpack Transceiver 2110 series Reference Manual 437
selcall command
Use the selcall command to make a Selective call to an addressed station.
Syntax
selcall <address of called station>[@<network>] [s] [from
<self address>[@<network>]]
where:
<address of called station>[@<network>] is the address [and network] of
the station you want to call.
s makes the call in Silent Mode.
from <self address>[@<network>] is the self address [and network] you want
to use for this call.
NOTE
You cannot use the ALL, ANY, Group Selective, NET, or Wildcard
address syntax with a selcall command.
NOTE
For more information on:
• address syntaxes see page 406, Addresses in commands
• call options see page 407, ALE call options
NOTE
If the network specified is ALE/CALM, the call is an ALE call, and the
ALE call options are available.