Using the 9350 Automatic Tuning Whip Antenna with a 2110 Manpack Transceiver
52 Manpack Transceiver 2110 series Reference Manual
Installing the cables
The cabling must be in a position that:
• is away from operator’s feet
• is secured and concealed as much as possible
• ensures the control cables are separated from the DC power cable by at least
200 mm (8 in), except over short distances where they may pass through the same
hole in a bulkhead
• is secured behind protective metalwork (only if the cables run under the vehicle)
Keep cables in the engine compartment away from:
• heat, for example, exhaust, air-conditioning systems, and water pipes
• oils and corrosive liquids, for example, engine oil, battery fluid, and brake fluid
WARNING
Do not cut the control, coaxial or speaker cable. If the cables are too long,
gather the excess neatly and secure it out of the way.
CAUTION
Large magnetic fields can be generated along the power cable during
transmission and these fields may be coupled into the control cabling.
Failure to keep these cables separated causes distortion of the transmitted
signal.
To Next Page
Loading...
