Operating the transceiver from a computer
Manpack Transceiver 2110 series Reference Manual 441
sound command
If you have the MIL-STD-188-141B ALE option installed, you can use the sound
command to:
• display the current status of ALE sounding operations, that is, on or off
• enable or disable ALE sounding operations
• initiate an ALE sounding operation
The sound command may be used regardless of the scanning state of the transceiver.
The sounding occurs in all ALE/CALM networks that have a valid self address and are
set to be scanned. ALE sounding operations do not occur if the transceiver is in a link
with another transceiver.
Syntax
sound
sound on
sound off
sound now [from <self address>[@<network>]]
where:
sound displays the current status of ALE sounding operations.
on enables automatic ALE sounding to occur in networks that have a sounding interval
set (see page 151, Programming the Network List).
off disables automatic ALE sounding operations from the command interface.
now initiates an ALE sounding operation in all ALE/CALM networks that have a valid
self address and are set to be scanned.
from <self address>[@<network>] initiates an ALE sounding operation on the
specified self address in all ALE/CALM networks [or the specified network] that are set
to be scanned and for which this self address is valid.
To Next Page
Loading...
