Codan 2110 series User Manual

Operating the transceiver from a computer
430 Manpack Transceiver 2110 series Reference Manual
pagecall command
Use the pagecall command to send a written message to another station. The
receiving station automatically sends an acknowledgment response when the call is
received.
Syntax
pagecall <address of called station>[@<network>] "<message>"
[from <self address>[@<network>]]
where:
<address of called station>[@<network>] is the address [and network] of
the station to which you want to send the message.
NOTE
The permitted message length depends on the type of call system, the
privacy mode selected, and the character set (see Table 67).
Table 67: Variations in message length
Call system Privacy mode Character set Maximum message length
(number of text characters)
ALE/CALM Plain ASCII-64 83 to 90
ALE/CALM None ASCII-256 64 to 84
ALE/CALM Group ASCII-256 50
ALE/CALM Registered ASCII-256 50
Codan Selcall None ASCII-127 64
Codan Selcall Group ASCII-256 64
Codan Selcall Registered ASCII-256 64
Open Selcall N/A ASCII-64 32
NOTE
ASCII-64: This protocol uses all upper-case and numeric characters and
some punctuation characters.
NOTE
ASCII-127: This protocol uses all printable ASCII characters up to
decimal 127.
NOTE ASCII-256: This protocol uses full binary encoding of all 8-bit characters.
NOTE
For more information on:
• address syntaxes see page 406, Addresses in commands
• call options see page 407, ALE call options
• recognised variables see page 408, Recognised variable expansion

Codan 2110 series Specifications

General

Brand	Codan
Model	2110 series
Category	Transceiver
Language	English