Operating the transceiver from a computer
436 Manpack Transceiver 2110 series Reference Manual
selbeacon command
Use the selbeacon command to test the quality of a selected channel before you use it
to transmit voice or data. The command sends a request to the station you want to call on
the channel you have selected. This receiving station automatically responds with an
audible test signal. The volume and clarity of the returned signal indicates the quality of
the channel.
Syntax
selbeacon <address of called station>[@<network>] [s] [from
<self address>[@<network>]]
where:
<address of called station>[@<network>] is the address [and network] of
the station you want to call.
s makes the call in Silent Mode.
from <self address>[@<network>] is the self address [and network] you want
to use for this call.
NOTE
You cannot use the ALL, ANY, Group Selective, NET, or Wildcard
address syntax with a selbeacon command.
NOTE
For more information on address syntaxes see page 406, Addresses in
commands.
To Next Page
Loading...
Need help?
General
