Operating the transceiver
90 Manpack Transceiver 2110 series Reference Manual
Setting the basics
Setting the time and date
When the transceiver leaves the factory it is set to UTC time with a time zone offset of
zero. To set your local time and date you must enter your time zone offset from UTC
time, then adjust the local time and date if necessary. This feature is useful if you have a
network that spreads over several time zones, or you need to time stamp your
transmissions according to the current time at longitude zero.
Setting the time zone offset
To set your time zone offset from UTC time:
1 Press until Main Menu is displayed.
1 Scroll to Control, then press .
1 Scroll to Time..., then press .
1 Scroll to Zone Offset, then hold .
1 Scroll to the correct time zone offset for your location, then press .
1 Press until Main Menu is displayed.
NOTE
In the following discussion, you must log in as administrator to see the
Main Menu (see page 128, Logging in to admin level from user level).
To Next Page
Loading...
Need help?
General
