Hot key examples
394 Manpack Transceiver 2110 series Reference Manual
Example 7: setting up one-touch discreet operation
This example shows you how to create a macro that puts your transceiver into discreet
operation.
When you run this macro, the transceiver switches off the following:
• the internal speaker
• alert tones
• backlighting
• key beeps
This macro is created by joining four macros together.
To create this macro:
1 Log in to admin level (for help see page 128, Logging in to admin level from user
level).
1 Create separate macros to perform the following tasks:
1 Join the macros together, selecting Speaker as the first macro each time (see
page 347, Joining macros).
1 Rename the Speaker macro to Discreet.
1 Delete the Tones, Dark and Beeps macros.
Control List entry Selected setting Macro action Timing Assign to Name
Cfg Speaker Internal Disabled Set this value Immediately Unassigned Speaker
Cfg Alert Tones Disabled Set this value Immediately Unassigned Tones
Screen Brightness ( + 0) Dark Set this value Immediately Unassigned Dark
Key Beep Off Set this value Immediately Unassigned Beeps
NOTE
For help see page 390, Example 3: displaying and/or changing a
setting in the Control List.
NOTE
The internal speaker is switched on again by holding MUTE, and the
screen backlighting is changed by pressing . If the user needs to
restore key beeps and alert tones, you should create new macros that
enable the user to switch on these settings (see page 390, Example 3:
displaying and/or changing a setting in the Control List).
To Next Page
Loading...
Need help?
General
