The Channel List
Manpack Transceiver 2110 series Reference Manual 137
Programming the Channel List
Creating a channel
This section covers creating a channel in a transceiver where receive and transmit
frequencies can be entered.
To create a channel:
1 Press VIEW until the channel screen is displayed.
1 Use the List Manager to create an entry (for help see page 113, Creating an entry in
a list and page 72, Entering and editing text).
1 Enter the setting information provided in the following table as required, then
press to enter the information.
NOTE
If you are operating the transceiver in a country that has stringent
licensing regulations, you may not be permitted to create channels with
transmit frequencies.
NOTE
If the TxD option is installed in the transceiver, there are restrictions on
the frequencies you can enter.
NOTE
If the TxP option is installed in the transceiver, you cannot create
channels.
NOTE
You may be permitted to create a channel in free tune. For more
information see page 335, Creating a channel in free tune.
NOTE If the Channel List is empty, Free Tune is displayed.
If this prompt is
displayed...
Do this...
Receive Freq • use this frequency, or
• enter a new receive frequency in kilohertz
NOTE
You can enter the frequency to three decimal
places. Press
*
to enter a decimal point, then
continue with entering the frequency.
To Next Page
Loading...
Need help?
General
