Operating the transceiver from a computer
Manpack Transceiver 2110 series Reference Manual 427
link command
If you have the MIL-STD-188-141B ALE option installed, you can use the link
command to display the current link status of the transceiver.
Syntax
link
where:
link displays the current link status of the system.
lock command
Use the lock command to:
• display the current lock status of the transceiver
• set whether or not the transceiver is locked
• break or steal a lock from another interface
When a lock is on the transceiver, it only responds to the interface issuing the command,
that is, CICS. When more than one lock is on, a single lock off command releases the
entire system.
Syntax
lock
lock on
lock off
lock abort|break|steal
where:
lock displays the current lock state of the system.
on attempts to lock the system.
off releases the lock(s) on the system.
abort attempts to break a lock from another interface.
break releases this lock or another device’s lock.
steal overrides normal locks, but not Emergency calls.
To Next Page
Loading...
