Codan 2110 series - Statusack Command

Operating the transceiver from a computer
442 Manpack Transceiver 2110 series Reference Manual
statusack command
The statusack command is used to send a reply to a Get Status call you have
received. A status call acknowledgment response contains the status information
requested. It is sent automatically if a status call requesting remote diagnostics (1) was
sent (see page 443, statuscall command). The statusack command must be sent
within the timeout period specified by the station that sent the call (see page 444,
statustime command).
Syntax
statusack <address of called station>[@<network>]
"<message>"
where:
<address of called station>[@<network>] is the address [and network] of
the station that requested the status information.
<message> is the status information requested by the station that sent the status call.
The message is sent within single or double quotes to allow the use of spaces in the
message.