Using the 9350 Automatic Tuning Whip Antenna with a 2110 Manpack Transceiver
48 Manpack Transceiver 2110 series Reference Manual
Mounting positions that are recommended in a mobile installation include:
• the transmission hump
• in place of the glove box
• behind the seat
• under the dashboard (if safe)
The mounting position must ensure sufficient cable length is provided to allow the
removal of the equipment from the cradle with the various cables connected.
Positioning the antenna
For information on positioning a mobile antenna, see the documentation provided with
the antenna.
Grounding the antenna
For information on grounding a mobile antenna, see the documentation provided with
the antenna.
WARNING
The units of the mobile station should only be mounted on structural
components of the vehicle body and not to dress panels. The areas used
for mounting may require reinforcement.
WARNING
Do not mount the transceiver on a cargo barrier as this may void the
vehicle manufacturer’s warranty.
WARNING
The antenna should be installed by a suitably qualified technician, to the
relevant standards and approvals.
WARNING
While the following information is intended to assist with positioning the
antenna, it is the purchaser’s responsibility to ensure that the 9350
Automatic Tuning Whip Antenna is installed with due regard to
pedestrian and vehicle-occupant safety, particularly in the event of a
vehicle accident. Codan accepts no responsibility or liability in the event
of injury to pedestrians or vehicle occupants or any other damage due to
insecure or otherwise unsafe or inappropriate installation of the antenna.
NOTE
Correct installation of the antenna provides efficient operation over the
frequency range of the transceiver. It ensures the antenna provides
maximum output power during transmission and clear reception of weak
signals.
NOTE
The 9350 Automatic Tuning Whip Antenna may be operated with a
2110 only.
NOTE
The 9350 Automatic Tuning Whip Antenna may be operated with a
2110 only.
To Next Page
Loading...
