The Network List
Manpack Transceiver 2110 series Reference Manual 151
Programming the Network List
Creating a network
When you create a network, the transceiver prompts you for various details. It is
recommended that you read page 144, Settings in the Network List before you create a
network.
To create a network:
1 Press until Main Menu is displayed.
1 Scroll to Network, then press .
1 Use the List Manager to create an entry (for help see page 113, Creating an entry in
a list and page 72, Entering and editing text).
1 Enter the setting information provided in the following table as required, then
press to enter the information.
NOTE
In the following discussion, you must log in as administrator to see the
Network List (see page 128, Logging in to admin level from user level).
If this prompt is
displayed...
Do this...
Scan Network? • select whether the network is scanned or not
NOTE
If you want to scan a voice network for
voice when the Mute Type is set to Selcall,
select Scan voice (see page 83, Muting the
transceiver).
Call System? • select the call system you want to use
Call Detect Time? • increase or decrease the call detect time, or
• scroll to the far left of the line until <default> is
displayed
Sounding Interval? • select the value you want to use
Privacy Mode? • select the mode you want to use
Privacy Password? • enter the password you want to use with the
privacy mode
Nominal Preamble? • increase or decrease the nominal preamble time,
or
• scroll to the far left of the line until <default> is
displayed
To Next Page
Loading...
Need help?
General
