The Network List
152 Manpack Transceiver 2110 series Reference Manual
The new network is created and the List Manager remains open.
1 If you want to view the network you have created, press to close the List
Manager.
Renaming a network
When you rename a network, references to the network in other lists are not
automatically updated; you must go to the Address entry in the Control List to update
any of your station self addresses that use the network, and to the Address, NET and
Phone Link Lists to update any entries that use the network.
For example, if the network you renamed is used in an entry in the Address List, go to
this entry, find the reference to the old network name, then change it so that the new
name is displayed (for help see page 183, Editing an entry in the Address List). If you do
not update the reference to the network, the transceiver prompts you to select a network
each time you use the entry to make a call.
Renaming a network is a standard list function. For help see page 114, Renaming an
entry in a list.
Copying a network
Copying a network is a standard list function. For help see page 114, Copying an entry in
a list.
Channel? • select the channel you want to use
NOTE
If the channel is in a group, scroll to the
group name, press , then scroll to the
channel you want to use.
If you want to use a group of channels,
scroll to the group name, then hold .
Mode? • select the mode for the channel or group of
channels you want to use
Add another Channel/
Mode?
• select the channel/mode you want to use
NOTE
If you do not want to add another channel/
mode, press .
If this prompt is
displayed...
Do this...
To Next Page
Loading...
Need help?
General
