To Next Page

To Previous Page

Controlling user access

474 Manpack Transceiver 2110 series Reference Manual

Controlling access to call types

You can specifically allow or restrict access to call types. The configuration command

for allowing access to call types begins with #$! ACT-. The configuration command for

restricting access to call types begins with #$! BCT-. Follow either of these commands

with the codes you want to use from Table 74. Separate the commands with a comma.

For example, if you want to allow access to using Selective call and Phone call types

only, enter the following into the Message 10 entry:

#$! ACT-S,P

If you want to restrict access to using Message call and Get Position call types, enter the

following into the Message 10 entry:

#$! BCT-M,GP

CAUTION Do not use the ACT and BCT commands at the same time.

NOTE

Incoming calls to the front panel and calling activity via CICS are not

affected by the ACT/BCT configuration command.

Table 74: Codes for controlling access to call types from the front panel

Code Description

AL ALL

AN ANY

CT Channel Test

E Emergency

GP Get Position

GRP Group Selective

GS Get Status

MMessage

NE NET

P Phone

SSelective

SP Send Position

WC Wildcard

NOTE

The CTE configuration command allows a Channel Test call using hold

CALL during the Select chan/mode prompt, even when the Channel Test

call type is blocked (see page 475, Controlling access to holding CALL).

Codan 2110 series User Manual

Other manuals for Codan 2110 series