Using the transceiver in free tune and Amateur Mode
332 Manpack Transceiver 2110 series Reference Manual
Using the transceiver in free tune
The transceiver can be used as a free-tune receiver. This enables you to tune to any
frequency within the transceiver’s operating range of 250 kHz to 30 MHz. In some
circumstances, the options installed on your transceiver may enable you to transmit
while free tuning, for example, the Amateur Mode option enables you to transmit during
free tune when tuned to amateur band frequencies (see Table 39 on page 336).
Entering a specific free-tune frequency
To enter a specific frequency:
1 Press FREE Rx.
1 Press .
1 Enter a new frequency or edit the existing frequency as required, then press .
1 Do one of the following:
• To exit to the screen from which you began, press FREE Rx.
• To exit free-tune receive, go to the Channel List and select another channel (for
help see page 71, Selecting a channel).
If you re-enter Free Tune prior to selecting another channel in the Channel List, the
selected frequency is the same as that last used.
NOTE
In the following discussion, you must log in as administrator to see the
Control List (see page 128, Logging in to admin level from user level).
To Next Page
Loading...
Need help?
General
