Operating the transceiver from a computer
454 Manpack Transceiver 2110 series Reference Manual
CICS error messages
Table 70: CICS error messages
Error message Description
ERROR: Admin access
required
The command that you entered requires an administrator login. Type
login admin, then press Enter. Enter the admin password for the
connected transceiver.
ERROR: ALE beacon not
allowed
The call type used for the call is not installed in the transceiver. Select
another call type, or if you want to use the call type, contact your
Codan representative.
ERROR: AMD call failed The message that you have sent within an established link has failed.
ERROR: Bad command The syntax of the command entered is incorrect. Use the help
command to look for the categories of available commands and use
the help <category> command to get information on the
available commands within a category. For information on CICS
functionality use the help cics command.
ERROR: Call failed The outgoing call has not started. This message is preceded by a
message stating the reason for the failure. Check the address and use
the selbeacon command to send a Channel Test call to the address
of the called station. You may need to select another frequency.
ERROR: Call reply error
XXX
There has been an internal problem making the call. Under normal
conditions this error should not occur. Switch the transceiver off then
on again.
ERROR: Call type not
allowed
This type of call cannot be made. Check if the option associated with
the call type is installed in the transceiver.
ERROR: Channel not
found
The channel you entered is not programmed in the transceiver. Either
program the channel into your transceiver, or select another channel
for the call.
ERROR: Citizen band
frequency but not
citizen band channel
You are not permitted to transmit on this CB frequency as it does not
correspond with a CB channel within the transceiver. Select another
frequency.
Error: Command failed The command you entered has failed. Check the syntax required for
the command.
ERROR: Data too long The message is too long. Shorten the message, or split the message
over a number of calls. The maximum number of characters permitted
in a call system is provided in Table 67 on page 430.
ERROR: FROM selfid
<self address> not
valid
The self address contains characters that are not permitted. Check that
the self address is correct for the type of network in which it is being
used (see page 92, Entering your station self address).
To Next Page
Loading...
Need help?
General
