Operating the transceiver from a computer
Manpack Transceiver 2110 series Reference Manual 455
ERROR: Internal error
ERROR: Internal error
XXXX
ERROR: Internal get
ERROR: Internal set
Under normal conditions this error should not occur. It is an
indication that something went wrong with internal processing.
Contact your Codan representative.
ERROR: Invalid address The address that you are using for the call contains characters that are
not permitted, or the statusack has an invalid source address. Check
all addresses for the call.
ERROR: Invalid call
options
The call options that you have entered for the call:
• do not match those allowed for the call system
• have been repeated
• are not recognised when inserted after a message
ERROR: Invalid call
type for network
The call type used for the call is not supported by the network. Select
a call type that is valid for the network, or select a different network.
ERROR: Invalid call
type or selfid for
scanning networks
You have started a call during scanning. CICS attempts to select the
first suitable network, however in this case, there are no suitable
networks.
Do one of the following before making the call again:
• switch off scanning
• specify the network for the call
• select a different call type
• select a different self address
ERROR: Invalid
characters in selfid
The self address contains characters that are not permitted. Check that
the self address is correct for the type of network in which it is being
used (see page 92, Entering your station self address).
ERROR: Invalid
destination address
The address of the called station used is incorrect for the call type or
network, for example, alpha characters in a Codan Selcall network.
Correct the address of the called station and try the call again.
ERROR: Invalid network
name
The name of the network used for the call does not exist or does not
support the call type (see page 144, Network Name).
ERROR: Invalid selfid
for specified address
The entry in the self address list is incorrect. Check that the self
address and assigned networks in the self address list are correct.
ERROR: Invalid selfid
for specified network
The self address contains characters that are not permitted by the
network specified, for example, alpha characters in a Codan Selcall
network. Correct the self address.
ERROR: Invalid selfid
network
The network in the self address list is incorrect. The self address list
has been updated with a network using the selfid command. The
network specified does not exist. Select a valid network for the self
address.
Table 70: CICS error messages (cont.)
Error message Description
To Next Page
Loading...
Need help?
General
