Operating the transceiver from a computer
444 Manpack Transceiver 2110 series Reference Manual
statustime command
Use the statustime command to specify the amount of time that the receiving station
has to respond to a status call (see page 443, statuscall command). The response can be
the requested information (STATUSACK), or a STATUSNACK.
If a statusack response is not received on the CICS port of the receiving station
within this time, a message is displayed to inform you of this.
You can use the statustime command to:
• display the current statustime
• set a new statustime
Syntax
statustime
statustime <timeout value>
where:
statustime displays the current timeout value (in seconds).
<timeout value> sets the time (in seconds) in which the receiving station has to
respond to a statuscall command.
Limitations
The timeout value is local to this CICS interface.
NOTE
Be aware that the 2110 Manpack Transceiver adds 45 seconds to the
status time you have entered. For example, if you have entered 10 seconds
for the statustime, the receiving station has 10 seconds to prepare the
response and 45 seconds to send the call to the requesting station.
To Next Page
Loading...
Need help?
General
