The Control List
Manpack Transceiver 2110 series Reference Manual 241
ALE entries
ALE Accept ALL Call
ALL calls are not addressed to a specific station. If your station detects a call with a
matching ALL address syntax, it enters the linked state and alerts the operator. If you do
not want to receive either global or selective ALL calls, disable this feature.
ALE Accept ANY Call
ANY calls are not addressed to a specific station. If your station detects a call with a
matching ANY address syntax, it sends a response (random slot) to the initiating station.
Your station enters a link when it receives an acknowledgement from the initiating
station. If you do not want to receive either global or selective ANY calls, disable this
feature.
ALE Accept Wildcard Call
Wildcard calls are not addressed to a specific station. If your station detects a call with a
matching Wildcard address syntax, it sends a response (random slot) to the initiating
station. Your station enters a link when it receives an acknowledgement from the
initiating station. If you do not want to receive Wildcard calls, disable this feature.
NOTE
You must have the FED-STD-1045 ALE/CALM option installed to use
the ALE entries in the Control List.
NOTE
In the following discussion, you must log in as administrator to see the
Control List (see page 128, Logging in to admin level from user level).
NOTE
The initial values that are set in your transceiver by Codan should provide
good performance.
CAUTION
Do not attempt to change the ALE settings in the Control List unless you
are familiar with ALE operation. For more information on ALE, refer to
FED-STD-1045 ALE and MIL-STD-188-141B.
NOTE
The ALE Accept ANY Call entry is available if you have the MIL-STD-
188-141B ALE option installed (2110 only).
NOTE
The ALE Accept Wildcard Call entry is available if you have the MIL-
STD-188-141B ALE option installed (2110 only).
To Next Page
Loading...
Need help?
General
