Operating the transceiver from a computer
408 Manpack Transceiver 2110 series Reference Manual
Recognised variable expansion
The variables listed in Table 64 may be added in a message with any command. These
variables are recognised by CICS V3.20 (or later) when they are enclosed in double
quotes. CICS expands the variable by inserting the current information associated with
the variable into the message.
To... Type...
Enable LQA for a call +lqa
Disable LQA for a call –lqa
Enable LBT for a call +lbt
Disable LBT for a call –lbt
Make a call using the current channel only thischan
Enable a scan cycle on all scanned networks between
call attempts
+scan
Disable the scan cycle between call attempts –scan
NOTE $GPS and $GPS+ variables require Option GPS Enable to be installed.
Table 64: Variable expansion in a command
Keyword Function when used in a call or beacon command
$DATE Inserts the current date in the following format:
<name of day> <month> <day> <year>
$GPS Inserts the current valid GPS position in the following format:
<latitude> <longitude>
$GPS+ Inserts the current valid GPS position in the following format:
<latitude> <longitude> <altitude> <UTC>
$TIME Inserts the current time in the following format:
<hh>:<mm>:<ss>
$TZ Inserts the time zone offset in the following format:
<time zone offset>
$VER Inserts the current version of the transceiver unit firmware in the following
format:
<version number>
To Next Page
Loading...
Need help?
General
