The Control List
250 Manpack Transceiver 2110 series Reference Manual
Auto Resume entries
The auto resume entries—Auto Resume Time, Auto Resume Mode and Auto Resume
Listen—enable you to set the transceiver to automatically begin a task when scanning is
switched off and there has been no PTT, channel change, scan on/off, mute on/off, or call
sending activity for a certain length of time.
Use the Auto Resume Time entry to specify the time you want the transceiver to wait
since the last key was pressed, before it begins the task. You can select from 1 to
20 minutes.
Use the Auto Resume Mode entry to specify the task that is performed after the time
period. If you:
• want the transceiver to start scanning, select Start scan
• want the transceiver to close the link to end any call in progress and, if it was
scanning prior to the call, resume scanning, select Close link
• do not want the transceiver to resume scanning, select Off
If you select Start scan as the value in the Auto Resume Mode entry, use the Auto
Resume Listen entry to specify the scan method you want to use. If you want the
transceiver to:
• scan according to the value set in the Mute Scan entry, select Leave as is
• scan for voice and calls addressed to your station, select Voice and calls
• scan only for calls addressed to your station, select Calls only
NOTE
In the following discussion, you must log in as administrator to see the
Control List (see page 128, Logging in to admin level from user level).
NOTE
If the scan method is altered by the user, the transceiver returns to the scan
method specified in the Auto Resume Listen entry following the time that
is specified in the Auto Resume Time entry.
To Next Page
Loading...
Need help?
General
