Operating the transceiver from a computer
Manpack Transceiver 2110 series Reference Manual 423
freq command
Use the freq command to:
• display the receive and/or transmit frequencies of the current channel in the
transceiver
• select a channel by the receive frequency
Syntax
freq
freq <frequency>
where:
freq displays the receive and/or transmit frequencies of the current channel.
<frequency> specifies a receive frequency value in kilohertz. The transceiver
searches for a channel with this frequency. If an exact match cannot be found, the
channel with the next higher receive frequency is selected.
Compatibility with CICS V2
CICS V2 does not accept a decimal point in the freq command. If you need to maintain
compatibility with CICS V2 or less, do not enter a frequency with a fraction part.
Limitations
When you select a channel by frequency, CHAN: <name> is displayed when the
transceiver changes the channel to match the frequency you requested. If the transceiver
is already on a channel that matches this frequency, only the frequency is displayed.
NOTE
Specify the frequency in kilohertz and use a decimal point (.) to specify a
fraction part.
To Next Page
Loading...
