Operating the transceiver from a computer
450 Manpack Transceiver 2110 series Reference Manual
CICS response messages
Table 69: CICS response messages
Response message Description
ALE-EXIT: <address> The station specified has hung up from the link.
ALE-JOINED: <address> The station specified has responded to an ANY, Group
Selective, NET, or Wildcard call. The ANY, NET, and
Wildcard calls may also contain multiple addresses.
ALE-LINK: <channel>, <caller
address>, <self address>,
<time>
An ALE link has been established.
ALE-LINK: FAILED The ALE link between your transceiver and the station
you are calling has failed because the outgoing call was
not started or was aborted. This message is preceded by a
message stating the reason for the failure.
ALE-REPLY: <caller address>,
"<message>"
The station specified has replied to your call with an
AMD message.
CALL DETECTED A call has been detected.
CALL FAILED An outgoing call has not started or was aborted. This
message is preceded by a message stating the reason for
the failure.
CALL SENT An outgoing call has been sent.
CALL STARTED An outgoing call has been initiated.
CHAN: <name> The transceiver has changed the channel to that specified.
This message is only displayed when the system is not
scanning.
Names that include spaces are displayed within double
quotes.
CICS: V<version number> The current version status of CICS.
ECHO: OFF Echo is switched off, that is, half duplex mode.
ECHO: ON Echo is switched on, that is, full duplex mode.
EMERGENCY: <channel>, <caller
address>, <address of called
station>, <date> <time>[, <gps
position>|NO GPS UNIT
CONNECTED|NO VALID GPS POSITION]
An Emergency call has been received.
FREQ: xxxxx.x RX, INHIBIT TX The receive frequency of the current channel. The
transmit frequency is inhibited or it is a TxD channel.
FREQ: xxxxx.x RX, yyyyy.y TX The receive and transmit frequencies (in kHz) of the
current channel.
To Next Page
Loading...
Need help?
General
