Codan 2110 series User Manual

System messages
368 Manpack Transceiver 2110 series Reference Manual
Call error:
message too long
The message you have entered has too many characters. The
permitted message length depends on the type of call system, the
privacy mode selected, and the character set (see Table 67 on
page 430). Reduce the length of your message.
Call error:
no GPS info to send
You have attempted to make a Send Position call but the transceiver
did not have any GPS information to send. This may be because the
transceiver has not received any valid GPS data and/or because it has
not been correctly configured to operate with a GPS receiver. Check
that:
• the cable between the GPS receiver and the transceiver is
connected correctly
• the value in the RS232 Mode entry in the Control List is set to
GPS
• the data rate in the RS232 Speed entry in the Control List is set to
the correct data rate for the GPS receiver
Try the call again.
Call error:
stop scan then retry
An error occurred when the transceiver tried to stop scanning. Press
SCAN to stop scanning, then try the call again.
Call failed:
auto timeout exceeded
An automated part of a call took too long. The transceiver has ended
the call.
Call failed:
could not connect
The transceiver could not connect to the station you called because:
• the station did not respond
• the channel was of poor quality
Try again later.
Call failed:
no response received
The transceiver did not receive a response from the station you called.
Try the call on a different channel.
Call finished:
No GPS unit connected
The transceiver made a Get Position call to a remote transceiver that
does not have a GPS receiver connected.
Call rejected:
check call details then retry
The transceiver could not make the call because:
• one or more details of the call were incorrect
• the system was busy
Check the details of the call and/or wait for 10 seconds before you try
the call again.
Call sent
<call type icon> <address>
The Emergency or Selective call you made in a Codan Selcall
network has been sent to the other station. Hold down PTT then
speak.
Call success
<call type icon> <address>
The Emergency or Selective call you made in an ALE/CALM
network has been automatically answered by the other station. Hold
down PTT then speak.
Table 53: System messages (cont.)
Message Description

Codan 2110 series Specifications

General

Brand	Codan
Model	2110 series
Category	Transceiver
Language	English