Codan 2110 series User Manual

System messages
Manpack Transceiver 2110 series Reference Manual 369
Call type
not installed: <call type icon>
The option to make this type of call has not been installed in the
transceiver. Select a different call type or, if you know the option code
for the call type, enter it using the Option code setting under the
Devices entry in the Control List (see page 253, Installing an option
in the transceiver).
Call warning:
Message has been truncated
to <maximum length for call
system> characters
The message sent with the call is too long for the selected calling
system. The transceiver has truncated the message to the maximum
permitted for the calling system.
Calling...
<call type icon> <address>
Your call has started. Wait for the next message.
Calling...
Send message
You are sending a message within an existing ALE link to the in-link
address.
Call trying <name of channel>/
<name of mode>
You have started a call in an ALE/CALM network. The transceiver is
attempting to make the call on the channel/mode displayed.
Can’t charge
...Too hot
The battery monitoring system has detected that the temperature is
too high for charging. Wait until the battery temperature lowers, then
try charging the battery again.
Can’t change
frequency
You cannot edit frequencies in this transceiver.
Can’t change
mode
You cannot change the mode on the current channel for one of the
following reasons:
• The mode you want to set is not an allowed mode for the channel.
Select another mode.
• The channel/mode is locked. You may be able to unlock it if you
are logged in at the same level.
• The TxD option is installed in the transceiver which prevents you
from changing modes on transmit channels. For more
information contact your system administrator.
Can’t change
mode: channel has changed
The channel has been reprogrammed and the mode is no longer valid.
Can’t change
mode: tcvr is scanning
You cannot change the current mode because the transceiver is
scanning. Press SCAN to stop scanning, then try again.
Can’t clarify
chan: tcvr is scanning
You cannot use the clarifier while the transceiver is scanning. Press
SCAN to stop scanning, then try again.
Table 53: System messages (cont.)
Message Description

Codan 2110 series Specifications

General

Brand	Codan
Model	2110 series
Category	Transceiver
Language	English