Codan 2110 series User Manual

System messages
370 Manpack Transceiver 2110 series Reference Manual
Can’t edit
this item
You have used a macro to go to a setting that can no longer be edited.
For example, you created a macro to go to the Message setting of an
entry in the Address List. You then changed this entry to make a
Selective call instead of a Message call. The message setting is no
longer relevant to the entry so it is not displayed. When you use the
macro, however, it still tries to go to this setting.
To avoid this message, delete the macro.
Can’t make
Chan Test call <reason>
You have attempted to make a Channel Test call in a situation that
does not allow it. These situations include making a Channel Test
call:
• in an ALE/CALM network (requires the MIL-STD-188-141B
ALE option)
• in a Voice Only network
• to NETs that link immediately (requires the MIL-STD-188-141B
ALE option)
• using an ALL address syntax
Can’t modify
<name of macro> macro
You have attempted to modify a macro stored in the Special entry in
the Keypad List. Make a copy of the macro first, assign the copy to a
key or to the Unassigned entry in the Keypad List, then modify the
copy.
Can’t toggle
scan: try again
An error has occurred while switching scanning on or off. Press
SCAN to toggle scanning.
Can’t tune:
tcvr is scanning
You have attempted to manually tune the antenna while the
transceiver is scanning. Press SCAN to stop scanning, then try again.
Chain call
ended
You have ended a chain call by pressing a key.
Channel busy:
<name of channel>/<name of
mode>
The channel/mode on which you are attempting to make a call is
busy.
Channel busy:
Try again later
Your call cannot be made because the channel is busy. Wait for the
channel to clear, or select a different channel, then try again.
Channel List
is empty
There are no channels in the Channel List. Create one or more
channels.
Channel not
found: <name of channel>
The channel/mode on which you are attempting to make a call is in
the channel/mode list of the network you are using, but it is not in the
Channel List. Start the call again and select another channel/mode.
To avoid this message, delete the channel/mode from the network.
Channel Test
...listen
Listen for the revertive from the station you called.
Table 53: System messages (cont.)
Message Description

Codan 2110 series Specifications

General

Brand	Codan
Model	2110 series
Category	Transceiver
Language	English