Operating the transceiver
78 Manpack Transceiver 2110 series Reference Manual
Quick Start
Quick Start provides a simple way of:
• adding channels
• assigning channels to a scan list
• setting the time and date
• setting the self address of your station
• adding, changing or deleting entries from lists
Quick Start is available if your transceiver has not been programmed with a profile, or
contains only one station self address and network names from this default list:
•*Voice
•*Selcall
•*CALM
• !Default
Quick Start is accessed via the key. Standard List Manager functions as described on
page 107, The List Manager are accessed through the Advanced... entry in the List
Manager when Quick Start is available. When Quick Start is disabled by entering a non-
default network name or by entering more than one station self address, all List Manager
functionality is accessed directly by holding the key.
In countries that do not permit programming of transmit frequencies using the front
panel, you are not able to add channels using Quick Start; this is achieved using NSP.
Opening and closing Quick Start
To open Quick Start:
1 Hold .
To close Quick Start:
1 Press or hold .
NOTE
You can set up Quick Start using configuration commands in the
Message 10 entry in the Control List (see page 470, Controlling access to
the List Manager).
To Next Page
Loading...
