Operating the transceiver
Manpack Transceiver 2110 series Reference Manual 79
Adding/Editing a channel
To add or edit a channel:
1 Hold to open Quick Start.
1 Scroll to Add/Edit channel, then press .
1 Enter the name of the channel you want to create, then press .
If you want to use an existing channel, scroll to the channel, then press .
1 Enter the receive frequency in kilohertz, then press .
1 Enter the transmit frequency in kilohertz, then press .
1 Scroll to the mode combination you want to use, then press .
The transceiver returns to Quick Start.
1 If you want to add/edit more channels in your transceiver, scroll to Add/Edit
channel, then repeat this process.
1 Press to close Quick Start, if required.
NOTE
If you have option TxD installed, you are not able to program transmit
frequencies.
If you have option TxP installed, the Add/Edit channel entry is not
available.
NOTE For help with entering text see page 72, Entering and editing text.
NOTE
You can enter the frequency to three decimal places. Press
*
to enter
a decimal point, then continue with entering the frequency.
NOTE
If you want to make or receive calls on this new channel, you must
add it to your scan list.
To Next Page
Loading...
Need help?
General
