Operating the transceiver from a computer
Manpack Transceiver 2110 series Reference Manual 445
telcall command
Use the telcall command to make a call to a telephone number.
Syntax
telcall <address of called station>[@<network>] <telephone
number> [from <self address>[@<network>]]
where:
<address of called station>[@<network>] is the address [and network] of
the station with a radio/telephone interconnect unit.
<telephone number> is the telephone number to be dialled by the radio/telephone
interconnect unit.
from <self address>[@<network>] is the self address [and network] you want
to use for this call.
ver command
Use the ver command to display the version of CICS that is being used.
Syntax
ver
NOTE
Before you can make a Phone call you must know the address of a station
with a radio/telephone interconnect unit through which your call can be
routed to the public telephone network.
NOTE
For more information on:
• address syntaxes see page 406, Addresses in commands
• call options see page 407, ALE call options
• recognised variables see page 408, Recognised variable expansion
To Next Page
Loading...
