The 2110 series Manpack Transceiver
Manpack Transceiver 2110 series Reference Manual 23
Hot keys
Hot keys enable you to perform a task quickly. The transceiver comes with some
standard hot keys programmed; the keys are labelled with the corresponding task
performed.
Table 3: Standard hot keys
Hot key Function
F1 Pressing F1 performs the macro assigned to this soft function key. By default, MUTE is
assigned to this key, so pressing F1 toggles mute on or off. For more information see
page 83, Muting the transceiver.
F2 Pressing F2 performs the macro assigned to this soft function key. By default, CALL is
assigned to this key, so pressing F2 starts a call. For more information see page 202,
Making a call.
F3 Pressing F3 performs the macro assigned to this soft function key. By default, SCAN is
assigned to this key, so pressing F3 switches off scanning, or if you were in a call, ends
the call and switches on scanning. For more information see page 84, Scanning
channels.
Hold MUTE Holding MUTE toggles the front panel speaker on or off.
TUNE Pressing TUNE displays the PTT tunes screen so that you can manually tune the
antenna. For more information see page 99, Manual tuning.
CLAR Pressing CLAR enables you to adjust the receive frequency to compensate for any
frequency offset between your transceiver and the remote transceiver. For more
information see page 100, Using the clarifier.
MODE Pressing MODE selects the next allowable mode programmed for the channel, usually
USB or LSB.
FREE Rx Pressing FREE Rx enters Free Tune mode in which you can adjust or enter a receive
frequency. For more information see page 332, Using the transceiver in free tune.
Tx PWR Pressing Tx PWR toggles the transmission power of the transceiver between Hi (25 W)
and Lo (5 W).
If a Codan 3160 Power Amplifier is connected, PA is also included in the power
options (2110 only).
V/S Pressing V/S toggles the mute type between Voice mute and Selcall mute. For more
information see page 83, Muting the transceiver.
NOTE
If an AES-256 digital voice encryptor is fitted to the transceiver, digital voice
only mute (D) may also be selected.
SEC Pressing or holding SEC enters secure mode, if the hardware option is fitted and
specific firmware is programmed into the transceiver and enabled. For more
information see page 273, CES-128 voice encryptor option, page 293, AES-256 digital
voice encryptor option, page 307, VP-116 voice encryptor option, or page 313,
AES-256 digital data encryptor option.
To Next Page
Loading...
Need help?
General
