The 2110 series Manpack Transceiver
24 Manpack Transceiver 2110 series Reference Manual
GPS Pressing GPS displays your current GPS position, if your transceiver has valid GPS
information and Option GPS Enable is installed. For more information see page 259,
GPS Screen entry.
EASITALK Pressing EASITALK toggles the DSP noise reduction algorithm on or off. For more
information see page 101, Reducing background noise with Easitalk™.
VIEW Pressing VIEW toggles between the channel screen and the Address List. If you are in
any other list, pressing VIEW displays the channel screen.
CALL LOGS Pressing CALL LOGS repeatedly steps through a number of call logs: Calls Out, Calls
In, Last Heard, then back to the screen from which you began. In these logs, you can
view the details of the calls or detected stations. For more information see page 216,
The Calls Out Log and page 221, The Calls In Log.
The Last Heard log is available if you have the MIL-STD-188-141B ALE option
installed (2110 only).
(Emergency)
Holding starts an automatic Emergency call transmission using call information
contained in the Emergency entries in the Address List (see page 176, Making several
different types of calls).
(Power) Pressing toggles the screen and keypad backlighting between the default setting and
off.
+ SEC Pressing + SEC enables you to erase all of the CES secure keys and AES secure
keys from the transceiver, if the encryptor hardware option is fitted and specific
firmware is programmed into the transceiver and enabled. For more information see
page 284, Erasing all of the CES secure keys, page 301, Erasing all of the AES secure
keys (voice), and page 324, Erasing all of the AES secure keys (data).
+ 9 Pressing + 9 enables you to change the default setting for the screen contrast. For
more information see page 96, Changing the screen contrast.
+ 0 Pressing + 0 enables you to change the default setting for the screen and keypad
backlighting. For more information see page 96, Changing the screen brightness.
+ Pressing + enables you to clear certain configuration settings from the transceiver,
then shut it down immediately. For more information see page 231, Cfg Abandon
Mode.
Table 3: Standard hot keys (cont.)
Hot key Function
To Next Page
Loading...
Need help?
General
