Operating the transceiver from a computer
Manpack Transceiver 2110 series Reference Manual 417
aletelcall command
Use the aletelcall command to select the best channel on which to establish a link
to an addressed station, then make a telcall on that channel. A telcall is a call to a
telephone number.
To disconnect the link, either:
•use the scan on command to close the link and resume scanning (see page 433,
scan command), or
•use the hangup command to terminate the link (see page 425, hangup command)
Syntax
aletelcall <address of called station>[@<network>]
<telephone number> [from <self address>[@<network>]]
where:
<address of called station>[@<network>] is the address [and network] of
the station with a radio/telephone interconnect unit.
<telephone number> is the telephone number to be dialled by the radio/telephone
interconnect unit.
from <self address>[@<network>] is the self address [and network] you want
to use for this call.
NOTE
Before you can use the aletelcall command, you must know the
address of a station with a radio/telephone interconnect unit through
which your call can be routed to the public telephone network.
NOTE
For more information on:
• address syntaxes see page 406, Addresses in commands
• call options see page 407, ALE call options
• recognised variables see page 408, Recognised variable expansion
To Next Page
Loading...
Need help?
General
