Operating the transceiver
Manpack Transceiver 2110 series Reference Manual 77
Entering text in an ALE call address
To enter the global ALL address syntax or a special ALE addressing character:
1 Ensure that you are in an editable call address screen in which you can enter upper-
case letters (A).
1 Do one of the following:
• To enter an @, press
*
once.
•To enter a ?, press
*
twice while the cursor is in the same space.
• To enter a comma, press
*
three times while the cursor is in the same space.
• To enter any upper-case letter, press the corresponding key.
• To enter a number, press # once to change to numeric text entry, then press the
corresponding key.
Saving text changes
To save the changes you have made in an editable screen:
1 Press .
The question mark is removed from the heading.
If you do not want to save the text, hold to discard the changes.
NOTE
If the FED-STD-1045 ALE/CALM option or MIL-STD-188-141B ALE
option is installed in your transceiver (2110 only), the
*
key may be used
to enter the global ALL address syntax (@?@) or special ALE addressing
characters easily.
NOTE
You can use any of the characters in the basic 38 ASCII subset (A to Z,
0 to 9, @ and ?) for the address.
To Next Page
Loading...
Need help?
General
