The Channel List
138 Manpack Transceiver 2110 series Reference Manual
The new channel is created and the List Manager remains open.
1 If you want to view the channel you have created, press to close the List
Manager.
Renaming a channel
When you rename a channel, references to the channel in other lists are not automatically
updated; you must go to the Address, Network and Phone Link Lists and update any
references to the channel.
For example, if the channel you renamed is used in a network, go to the channel/mode
list for the network, find the reference to the old channel name, then edit it so that the
new name is displayed (for help see page 153, Editing a network and page 149,
Channel/Mode). If you do not update the reference to the channel, the channel is not
scanned when scanning is switched on.
Renaming a channel is a standard list function. For help see page 114, Renaming an
entry in a list.
Transmit Freq • use this frequency, or
• enter a new transmit frequency in kilohertz, or
• disable the transmit frequency by pressing
repeatedly until the setting is empty
NOTE
If the TxD option is installed in the
transceiver, you cannot create channels with
new transmit frequencies. You can however,
create channels with the same transmit
frequency as an existing channel, and you
can disable transmit frequencies to create
receive-only channels.
Mode • enter a mode
NOTE
If multiple modes can be added to the
channel, scroll to the new mode, then
press . If you do not want to add another
mode, press .
NOTE
If you disabled the transmit frequency, dashes are displayed in place
of the transmit frequency.
If this prompt is
displayed...
Do this...
To Next Page
Loading...
Need help?
General
