The NET List
Manpack Transceiver 2110 series Reference Manual 159
Outgoing Calls
The Outgoing Calls setting enables you to set up your station to make calls to the NET,
or disable calling to the NET. Unless you need to restrict calling to the NET, you should
set the Outgoing Calls setting to Enabled for all stations in the NET, regardless of their
member status.
If you want to set up your NET so that only one station makes calls to the NET, set the
Outgoing Calls setting for the NET in that station to Enabled. Set the Outgoing Calls
setting for all other stations with this NET programmed to Disabled.
Incoming Calls
The Incoming Calls setting enables you to set up your station to receive all incoming
calls from the NET, receive calls only if you are a member of the NET, or disable
receiving calls from the NET.
If the station has the NET programmed, then it can receive calls from the NET if the
Incoming Calls setting is set to Enabled. If your station has the NET programmed but
you are not a member, and you do not want to receive any of the NET calls, set the
Incoming Calls setting to Members only. As your station is not a member of the NET,
it will not enter the link. If you are a member of the NET but do not want to receive any
calls from the NET, select Disabled.
Link
The Link setting determines how the initiating station links with the receiving stations. It
can link:
• only if it receives a response from a member station
• even if it doesn’t receive a response from a member station
• immediately
CAUTION
If the Link setting is set to Only if response, you must ensure that at
least one member station is set to receive an incoming call from the NET
and send a response to the link request.
CAUTION This setting must be the same in all member stations.
NOTE
Stations with the NET programmed only send a response to a NET call if:
• their self address is included in the Member Address setting for the
NET, that is, they are a member of the NET, and
• the Response setting in the NET List is set to Send
To Next Page
Loading...
Need help?
General
