A
B
C
D
E
F
G
H
L
M
N
P
section
D 5
76 1098/1098S - M.Y. 2007 - edition 00
Use and maintenance
The socket to which the cable (Measurement Module) (3) is to be connected is indicated on the screen with a capital letter: A, B
or C.
The values may be displayed in three different ways: in one numeric form and in two graphic forms; to select the desired display
type, press the “Value display” icon (H).
The measured value is indicated alongside the letter (A) or (C) identifying the cable used for the measurement: i.e. if you used
connector (A) of the cable (3), the measured value will be displayed next to the letter (A) on the screen.
The maximum pressure must be 3 bar (nominal).
On completion of the test, remove all the components of the test instrument and refit the fuel feed hose (19).
Refit the fuel tank-seat-cowling assembly (Sect. E 3).
H
19
To Next Page
Loading...
