A
B
C
D
E
F
G
H
L
M
N
P
section
G 1
71098/1098S - M.Y. 2007 - edition 00
Wheels - Suspensions - Brakes
Grease the bearing seat and then push the new bearing into its seat.
Using a tubular drift (B) that only bears on the outer race of the bearing, drive the bearing (5) fully into its seat.
Use the same method to install the oil seals (4).
Ensure that spacer (7) is fitted between the two wheel bearings.
Notes
Wheels must be rebalanced after repair, maintenance and overhaul operations.
Inspecting the wheel axle
Check the wheel axle for straightness.
Roll the axle on a flat reference surface and measure maximum runout using a feeler gauge (see Sect. C 1.1).
B
5
7
C
B
5
7
C
4
To Next Page
Loading...
