Ducati 1098 2007 - Page 361

A
B
C
D
E
F
G
H
L
M
N
P
section
M 3
111098/1098S - M.Y. 2007 - edition 00
Injection - ignition system
Make sure the clip (A) for the connector (8) is in its “open” position (as shown in the diagram).
Push the connector firmly into the ECU.
Rotate the clip (F) to secure the connector (clip in “locked” position).
Repeat the procedure for the other connector (9).
Make sure the connector clip is in the “open” position.
Push the connector firmly into the control unit.
Rotate the clip to secure the connector (clip in “locked” position).
Important
If the ECU is renewed, it will be necessary to reset the TPS to zero using the DDS tester (Sect. D 5).
clip in “open”
position
clip in “open”
position
8
9
F
clip in “locked”
position
clip in “locked”
position
8
9
WWW.PlanDeGraissage.ORG