A
B
C
D
E
F
G
H
L
M
N
P
section
N 9.2
2151098/1098S - M.Y. 2007 - edition 00
Engine
Check that the two locating dowels (22) are correctly installed.
Grease the O-ring (31) to hold it in position and install it.
Apply a uniform and continuous bead of DUCATI liquid gasket to the mating surfaces of the crankcase halves, going around all
the holes as shown in the figure.
Bring the crankcase halves (3) and (13) together, tapping with a rubber mallet in the area of the shafts if necessary.
22
22
31
3
13
To Next Page