A
B
C
D
E
F
G
H
L
M
N
P
section
P 4
62 1098/1098S - M.Y. 2007 - edition 00
Electric system
High beam headlights relay
The headlights relay (1) is located on the front subframe. To gain access to this component you must first remove the headlight
shell (Sect. E 1). A low beam lights relay (1) has been introduced into the system in order to reduce battery power consumption
by automatically switching off the headlight.
The device is triggered in two cases:
- in the first case, if you turn the key from OFF to ON and do not start the engine, After 60 seconds the headlight will be
deactivated and will only be reactivated the next time the key is turned from OFF to ON or the engine is started.
- in the second case, after normal use of the motorcycle with the lights on, if the engine is shut off using the ENGINE STOP
switch (2). In this case, 60 seconds after the engine is stopped, the headlight will be turned off and will only be turned on
again the next time the engine is started.
Notes
Also during engine starting, the system turns the headlight off and turns it back on once the engine has started.
If this strategy is not performed, check the correct operation of the various parts involved.
1
2
To Next Page
Loading...
