A
B
C
D
E
F
G
H
L
M
N
P
section
D 4
26 1098/1098S - M.Y. 2007 - edition 00
Use and maintenance
Open the bleed valve (3) or (5) by a 1/4 turn and operate the brake lever (or pedal) several times until the fluid starts coming out
of the bleed valve. Pull the lever fully in and loosen off the bleed valve by at least a 1/4 of a turn.
Wait a few seconds, then release the lever gradually while simultaneously closing the bleed valve (3) or (5).
Important
Do not release the brake lever (or pedal) until the bleed valve has been fully tightened.
Repeat the bleeding operation until air bubbles no longer come out of the plastic tube.
Bleed air out of the bleed valves one at a time.
Tighten the bleed valve (3) or (5) to the specified torque (Sect. C 3). Replace the dust cap.
To completely eliminate any air that could remain at the top of the front brake master cylinder, repeat the same procedure for the
bleed valve (6).
Top the fluid up to the correct level and tighten the screws (2) on reservoir (A) and replace cap (4) on reservoir (B).
5
6
To Next Page
Loading...
