A
B
C
D
E
F
G
H
L
M
N
P
section
D 4
36 1098/1098S - M.Y. 2007 - edition 00
Use and maintenance
Checking rear brake pad wear
Check through the slot between the two caliper halves that there is at least 1 mm of friction material on the pads.
Important
If either of the pads is worn, both pads must be renewed as a set.
Change the brake pads as follows:
Remove the safety clip (1) (on the inner side of the caliper) from the pad retaining pin.
Force the caliper pistons back into their bores by forcing the brake pads apart.
Withdraw the brake pad retaining pin (2) from the outside.
Remove the clip (3) from between the two caliper halves.
Remove the worn pads.
Notes
Change pads that have a shiny or “vitrified” appearance.
1 mm
2
To Next Page
Loading...
