FOR-A FA-9520 User Manual

23
3-2. For HD/SD-SDI Simul Output
It is possible to always output HD-SDI signal from SDI OUT1/2, and SD-SDI signal from SDI
OUT3/4 regardless of whether the input signal is HD or SD-SDI.
Settings that need to be checked:
 Set FS1 IN SEL to SDI1 in the FS INPUT SELECT menu (see section 5-6-1).
 Set FS2 IN SEL to SDI2 in theFS INPUT SELECT menu (see section 5-6-1).
 Set SDI1/2 to FS1 in the OUTPUT ASSIGN menu (see section 5-7-1).
 Set SDI3/4 to FS2 in theOUTPUT ASSIGN menu (see section 5-7-1).
 Set FS1 conversion mode (CONV) to 1080i or an HD format such as 720p in the CONV
MODE menu (see section 5-3-1).
 Set FS1 ASPECT to 16:9 P 4:3 in the CONV MODE menu (see section 5-3-1).
 Set FS1 SD ASPECT to 4:3 in the VIDEO INPUT SET menu (see section 5-6-2).
 Set FS2 conversion mode (CONV) to SD in the CONV MODE menu (see section 5-3-1.)
 Set FS2 ASPECT to 4:3 F 4:3 in the CONV MODE menu (see section 5-3-1).
* Change ASPECT and/or SD ASPECT settings if necessary.
AC100 - 240V 50/60 Hz I N 1
FAN2
SER. NO.
LAN2LAN1
REMOTE
DIGITAL AUDIO IN / OUT
7 / 85 / 63 / 41 / 2
ANALOG AUDIO
GENLOCK IN
COMPOSITE
OUT2OUT1IN
B
OUT4OUT3IN2OUT2OUT1
SDI
IN1
A
FAN1
AC100 - 240V 50/60 Hz IN2
Reference signal
(BB or Tri-level sync signal
synchronized with the input
signal.)
Terminate at 75
ohm if not used.
Input an HD/
SD-SDI signal
to SDI IN1.
Outputs an
HD-SDI signal
synchronized with
the reference
signal from SDI
OUT1 and 2.
Outputs an
SD-SDI signal
synchronized with
the reference
signal from SDI
OUT3 and 4.

FOR-A FA-9520 Specifications

General

Brand	FOR-A
Model	FA-9520
Category	Signal Processors
Language	English