FOR-A FA-9520 - How to Insert AFD Data to Output Video Signals

269
 FS1 and FS2 operation mode settings
 Set the AFD auto-conversion mode for CONV 1 in CONV MODE (Sec. 5-3-1).
 AFD output verification
AFD data status in FA1 and FA2 output video signals can be verified as follows:
 The ANC OUT menu (Sec. 5-10-23) allows you to verify whether and in which line the VI
and WSS data has been inserted into output video signals.
 VI and WSS output data details can be seen in VI OUT (5-10-25), and WSS OUT
(5-10-26).
 S2016-3 output data details can be seen in S2016 OUT (Sec. 5-10-24).
 Into which line S2016-3 is inserted can be seen inANC OUT1 (Sec. 5-10-27).
20-5. How to Insert AFD Data to Output Video Signals
FA-9520 can insert AFD data into input video signals that have no AFD data inserted.
 AFD system settings
To insert AFD data into output video signals, set basic operational settings in the VIDEO
SYSTEM menus as follows.
 Set ANC MODE to DETAIL in ANC SET (Sec. 5-9-6).
 Select the AFD data to insert, and which output to insert the data in ANC DATA EMBED
(Sec. 5-7-4). These settings are necessary when inserting AFD data into video signals to
be output from FS1 and/or 2.
 To enable devices that receive signals from FA-9520 to detect ancillary data, select the
ancillary data type, output video format/s for FS1 and/or 2 output/s, and line number into
which the data is to be inserted in ANC EMBED LINE (Sec. 5-7-5). The default setting
should be set to the line number usually used.
 FS1 and FS2 operation mode settings
 Set the converter operation mode in CONV MODE (Sec. 5-3-1).
 Set the specific aspect ratio under ASPECT in CONV MODE (Sec. 5-3-1). Select an
aspect ratio from among 4:3 L 16:9 T to 16:9F ALT4:3 for SD-SDI output video signals
from FS1/FS2. Select from among 16:9 L>16:9 to 16:9F ALT4:3 for HD-SDI output video
signals from FS1/FS2.
 AFD output verification
AFD data status in FS1 and FS2 output video signals can be verified as follows:
 The ANC OUT menu (Sec. 5-10-23) allows you to verify whether and in which line the VI
and WSS data has been inserted into CONV1 output video signals.
 VI and WSS output data details can be seen in VI OUT (5-10-25), and WSS OUT
(5-10-26)..
 S2016-3 output data details can be seen in S2016 OUT (Sec. 5-10-24).
 Into which line S2016-3 is inserted can be seen in ANC OUT1 (Sec. 5-10-27).