FOR-A FA-9520 - Page Jump Feature for Quick Menu Access

33
 AUDIO Menus (Lit orange)
The single down-arrow button consecutively displays menu pages from EMB1 IN GAIN of SDI
AUDIO to SOFT OPTION2 of OTHER in the menu list in section 4-2-2. On the other hand, the
single up-arrow button consecutively displays menu pages from SOFT OPTION2 of OTHER
to EMB1 IN GAIN of SDI AUDIO in the menu list.
* The EVENT button-assigned menus cannot be consecutively viewed. The consecutive
display mode is not supported for EVENT menus.
* While the menu display is in consecutive display mode, pressing the EVENT button
cancels the mode.
4-2-5. Page Jump Feature
Some menu buttons allow you to directly go to specific menus when they are held down for at
least 1 second. This feature helps you quickly check the state of specific settings.
Button mode
Button
Destination
Reference
VIDEO
CONV1
ANC SET(66)
5-9-6
VIDEO
CONV2
AFD IN STATUS(601)
5-10-20
VIDEO
IN SEL
VIDEO IN STATUS (502)
5-10-2
VIDEO
OUT SEL
VIDEO OUT STATUS (511)
5-10-4
AUDIO
SDI AUDIO
EMB1 IN AUDIO (551)
5-10-10
AUDIO
AES AUDIO
AES IN AUDIO(559)
5-10-12
AUDIO
ANALOG
ANALOG IN AUDIO(561)
5-10-13
AUDIO
AUDIO OP
*1
Dolby OP A AUX (591)
*1
or
Dolby OP B AUX (596)
*1
5-10-18
5-10-19
*1 The Dolby OP A AUX (591) or B AUX (596) menu is available only if an FA-95D-D or
FA-95DE-E option is installed in option slot A or B. The page jump feature is inoperative
while the FA-9520 is in the setting change confirming state. It becomes operable once
the change is confirmed. Refer to section 4-2-6. “Changing Setting Values” for details.
VIDEO
AUDIO