FOR-A FA-9520 - Keyer Set; Logo Position Setting Range

68
5-8-1-2. KEYER SET
Allows you to set a keyer for FS1 or FS2.
K E Y E R S E T
42
K E Y E R : O F F
LEVEL : 1 0 0 %
H P O S : 0 P I X E L
V P O S : 0 L I N E
Parameter
Default
Setting range
(Steps)
Description
KEYER
OFF
OFF
ON
Allows you to enable or disable the keyer for the
FS1 or FS2 output signal.
ON: Enables display of logos selected in the
LOGO SELECT menu (5-8-1-1).
LEVEL
*1
100%
0-100%
(0.1%)
Allows you to set a key level for a logo to be
output to the FS1 or FS2 output signal.
H POS
*1
0
*2
(2 Pixel)
Allows you to set the horizontal positon for a
logo to be output to the FS1 or FS2 output
signal.
V POS
*1
0
*2
(1 Line)
Allows you to set the vertical positon for a logo
to be output to the FS1 or FS2 output signal.
*1 Key level and position settings are saved for each logo ID. Changing logo settings for
FS1 will also change the logo settings of FS2 using the same logo.
*2 Actual logo position differs depending on the logo format selected when registering the
logo. See section 5-8-1-3 “Logo Position Setting Range” for details.
LEVEL and H/V POS settings are disabled under the following conditions:
 No logo is assigned to the logo ID selected under LOGO ID in the 5-8-1-1 LOGO
SELECT menu.
 Different formats are displayed for LOGO FORMAT and FS1 or FS2 in the 5-8-1-1
LOGO SELECT menu.
K E Y E R S E T
42
K E Y E R : O N
L E V E L : N O T A D J
H P O S : N O T A D J
V P O S : N O T A D J
5-8-1-3. Logo Position Setting Range
Positional settings will vary according to the logo formats as shown below.
Logo Format
H POS setting range
V POS setting range
SD 525
0 to 718
0 to 486
SD 625
0 to 718
0 to 575
HD 1080
0 to 1918
0 to 1079
HD 720
0 to 1278
0 to 719
The logo format selection is saved for each logo ID using FA-95LG GUI. See the separate
FA-95LG GUI Operation Manual for details.
FS1/LOCK
FS2/LOCK
Menu button
VIDEO OP
AUDIO OP